Config Lacp_Ports - D-Link DGS-1100-16/ME Reference Manual

config lacp_ports

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display LACP information for port1~3:
DGS-1100-24P/ME:admin#config lacp_port 1-3 mode active
Command : config lacp_port 1-3 mode active
Success.
DGS-1100-24P/ME:admin#
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
To configure settings for LACP compliant ports.
config lacp_ports <portlist> mode [active | passive]
The config lacp_ports command is used to configure ports that
have been previously designated as LACP ports.
<portlist> − Specifies a port or range of ports to be configured.
mode – Select the mode to determine if LACP ports will process
LACP control frames.
active – Active LACP ports are capable of processing and
•
sending LACP control frames. This allows LACP compliant devices
to negotiate the aggregated link so the group may be changed
dynamically as needs require. In order to utilize the ability to change
an aggregated port group, that is, to add or subtract ports from the
group, at least one of the participating devices must designate LACP
ports as active. Both devices must support LACP.
passive – LACP ports that are designated as passive cannot
•
process LACP control frames. In order to allow the linked port group
to negotiate adjustments and make changes dynamically, at one end
of the connection must have "active" LACP ports (see above).
Only administrator-level users can issue this command.
165