Config Loopdetect - D-Link DGS-1100-16/ME Reference Manual

Parameters
Restrictions
Example usage:
To disable the loopback detection feature on the Switch:

config loopdetect

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable loop back detection on the Switch:
DGS-1100-24P/ME:admin#config loopdetect ports all state enable
Command: config loopdetect ports all state enable
Success.
DGS-1100-24P/ME:admin#
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
on the Switch.
None.
Only administrator-level users can issue this command.
DGS-1100-24P/ME:admin#disable loopdetect
Command: disable loopdetect
Success.
DGS-1100-24P/ME:admin#
To configure the loop back settings on the Switch.
config loopdetect { interval_time <value 1-32767> |
lbd_recover_time <0, sec 60-1000000>] | trap [ none |
loop_detected ] | ports[ port_list <portlist> | all] state [enable |
disable]}(1)
The config loopdetect command configures the loop back
detection to be enabled or disabled for the specific ports on the
Switch and configures the loop back detection interval time, recover
time and trap on the Switch..
interval_time <value 1-32767> − Specifies the interval time of loop
back detection. The range is between 1 and 32767 seconds.
lbd_recover_time <0,sec 60-10000> − Specifies the recover time of
loop back detection on the switch. The range is between 60 and
10000 seconds.
trap [none | loop_detected] − Specifies the loop back detection trap
is enabled or disabled on the Switch.
port_list <portlist> − A port or range of ports to be configured.
all − All ports settings are to be configured.
[enabled | disabled] − Specifies the loop back detection is enabled or
disabled for the specified ports on the Switch.
Only administrator-level users can issue this command.
35