The LLDP commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
enable lldp
disable lldp
show lldp
show lldp remote_ports
config lldp
Each command is listed in detail, as follows:
enable lldp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable LLDP on the switch:
disable lldp
Purpose
Syntax
Description
Parameters
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
notification [enable | disable]
To enable LLDP on the switch.
enable lldp
The enable lldp command enables the Link Layer Discovery
Protocol (LLDP) on the switch.
None.
Only administrator-level users can issue this command.
DGS-1100-24P/ME:admin#enable lldp
Command: enable lldp
Success.
DGS-1100-24P/ME:admin#
To disable LLDP on the switch.
disable lldp
The disable lldp command disables the Link Layer Discovery
Protocol (LLDP) on the switch.
None.
LLDP COMMANDS
123
22