Show Loopdetect - D-Link DGS-1100-16/ME Reference Manual

To configure loop back detection with interval time 500 on the Switch:
DGS-1100-24P/ME:admin#config loopdetect interval_time 500
Command: config loopdetect interval_time 500
Success.
DGS-1100-24P/ME:admin#

show loopdetect

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the loop back detection information on the Switch:
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
To display the loop back detection information on the Switch.
show loopdetect [global | ports [portlist <portlist> | all]]
The show loopdetect command displays the loop back detection
information on the Switch.
global – Display the global setting of loop back detection.
portlist <portlist> − A port or range of ports to be displayed.
all − All ports settings are to be displayed.
None.
DGS-1100-24P/ME:admin#show loopdetect global
Command: show loopdetect global
LBD Global Settings
---------------------------------------------------
Status
Interval
Recover Time
Loopback Detection Trap : Disabled
DGS-1100-24P/ME:admin#
: Disabled
: 500 sec
: 60 sec
36