Create Mld_Snooping Multicast_Vlan; Config Mld_Snooping Multicast_Vlan - D-Link DGS-1100-16/ME Reference Manual

Restrictions
Example usage:
To delete the mld snooping static group:
DGS-1100-24P/ME:admin#delete mld_snooping static_group vlanid 1
ff1e::1
Command : delete mld_snooping static_group vlanid 1 ff1e::1
Success.
DGS-1100-24P/ME:admin#

create mld_snooping multicast_vlan

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a mld snooping multicast VLAN:
DGS-1100-24P/ME:admin#create mld_snooping multicast_vlan test 8
Command : create mld_snooping multicast_vlan test 8
Success.
DGS-1100-24P/ME:admin#

config mld_snooping multicast_vlan

Purpose
Syntax
Description
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
vlanid <1-4094> − The ID of the VLAN on which the MLD snooping
static group will be deleted. The range is from 1 to 4094.
<ipv6addr> − The multicast group IPv6 address.
Only administrator-level users can issue this command.
To create an MLD snooping multicast VLAN on the Switch.
create mld_snooping multicast_vlan <vlan_name 8> <vlanid 2-
4094>
The create mld_snooping multicast_vlan command creates a
MLD snooping multicast VLAN on the Switch.
<vlan_name 8> − The name of the VLAN on which MLD snooping
will be created. Up to 8 characters can be used.
<vlanid 2-4092> − The ID of the VLAN on which MLD snooping will
be created. The range is from 2 to 4094.
Only administrator-level users can issue this command.
To configure MLD snooping multicast VLAN on the Switch.
config mld_snooping multicast_vlan <vlan_name 8> { action
[add | delete] [member_port <portlist> | source_port <portlist> |
tag_member_port <portlist >] |state [enable | disable] |
replace_source_ip <ipv6addr> } (1)
The config mld_snooping multicast_vlan command configures
the MLD snooping multicast VLAN settings on the Switch.
107