Setting Up 3D Display; Setting 3D Format; Inverting 3D Signal; Selecting The 3D Sync Input Signal - Christie Inspire Series User Manual

Setting up 3D display

Use the functions in 3D Display menu to make the timing adjustment and environment necessary
for displaying 3D images.

Setting 3D format

Set up the 3D format according to the 3D input signal.
1. Select Menu > Image Settings > 3D Display > 3D Enable.
2. Select the appropriate 3D format:
• Auto
• Frame Packing
• Side by Side
• Top and Bottom
• Frame Sequential
• Dual Pipe
• 4K 3D
• 4K 3D Dual Pipe
• Off
3. To confirm the selection, select ENTER.

Inverting 3D signal

3D images consist of a series of images (frames) that alternate quickly between two slightly
different view points, corresponding to our left and right eyes. When these frames are displayed
fast enough and viewed with 3D glasses synchronized to the left/right (L/R) changes, the resulting
image appears with the same depth and perspective that is sensed in the real world.
If the projector generates the sync internally and content is displayed without 3D sync in the cable
connected to the projector, there is a 50% chance that the content is displayed with the left/right
eyes swapped. This function is used for swapping the sequence of the image to make the resulting
image appear normally.
1. Select Menu > Image Settings > 3D Display > 3D Invert.
2. To swap, select ENTER.

Selecting the 3D sync input signal

This function is used for selecting the 3D sync input option.
1. Select Menu > Image Settings > 3D Display > 3D Sync In Select.
2. Select the appropriate 3D sync in setting.
Inspire Series 4K User Manual
020-002098-01 Rev. 1 (09-2023)
Copyright © 2023 Christie Digital Systems USA Inc. All rights reserved.
If printed, please recycle this document after use.
Adjusting the image settings
37