Exabyte X200 Library Installation And Operation Manual page 99

LCD mode
To control robot movement from the operator panel, set the
library to LCD mode. Library operations that require LCD mode
to move the robot (such as cleaning the tape drives and
performing hardware exercises) are accessed from the
Maintenance Menu.
Note: You can set many operator panel features (for example,
Console mode
To control robot movement from Console mode, the library must
be connected to a remote terminal through the serial port.
Controlling robot movement from Console mode is typically used
only by service providers.
You do not need to switch to Console mode if you want to
upgrade the firmware or create diagnostic listings. For more
information about firmware upgrades and diagnostic listings, see
Chapter
Changing the control mode
1. Make sure the library is in the ready state (idle operating
2. If security is enabled, disable it (see
Installation and Operation
configuration options) without changing to LCD mode.
LCD mode is required only when you want to control the
motion of the robot from the LCD.
12.
status, no hardware errors, and so on).
Library Operation
page 62).
85