Table of Contents
Advertisement
Library Upgrades
Step 2 – Remove the service access cover
Before removing the service access cover, decide where you want
to install the new tape drive. Your software application may
require you to install the new tape drive in sequential order. (Refer
to your software documentation for information about element
address recognition.)
For example, the first two tape drives in the library occupy slots
451 and 452. If your library contains two tape drives and you want
to install a third drive in sequential order, install that drive in slot
453.
The following figure shows the element index numbers assigned
to the ten tape drives, as viewed from the back of the library. (Refer
to
page 155
for a complete numbering scheme of the library
element indexes.)
Rear view of tape drives
Installation and Operation
147
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the X200 Library and is the answer not in the manual?
Questions and answers