Exabyte X200 Library Installation And Operation Manual page 74

Chapter 4
7. Repeat steps
8. When the SCSI IDs for all of the tape drives and the library are
After you change the SCSI IDs and save the new settings, the
library changes the IDs and then waits until all of the affected
drives have accepted the new IDs.
Note: You do not need to power cycle the library to put the new
Setting library security
Setting security allows you to prevent unauthorized personnel
from disrupting the operation of the library. When you enable
security, the following activities are prevented:
ΠChanging the library configuration settings
ΠChanging the robot control mode
ΠUsing the operator panel to perform demos or diagnostics
ΠUsing the operator panel to perform tape drive operations
ΠCalibrating the library
ΠExtending the entry/ exit port (LCD security only; see
ΠOpening the front door (LCD security only; see
If you attempt to perform any of the above operations when
security is active, the library displays a message stating that
security is enabled and that the selected operation cannot be
performed until you disable security.
60
5 and
tape drives.
Note: If a drive slot is empty, "No drive" appears next to the
drive name, and you cannot change the SCSI ID.
correct, press >6DYH@ to accept your choices.
SCSI IDs into effect.
6 until you have set SCSI IDs for all of the
page 62)
page 62)
Exabyte X200