Setting The Number Of Slots - Exabyte X200 Library Installation And Operation Manual

Chapter 5
Replacing the cleaning cartridge
After completing each cleaning cycle, the library decreases the
Number of Cleans by one. When the Number of Cleans is zero,
the library disables Autoclean. A message appears on the Status
Screen, notifying you that the cleaning cartridge needs
replacement.
Disabling Autoclean
1. From the Configuration Menu, press >$XWRFOQ^ 6 HWXS@ .
2. Press >'LVDEOH^ $ XWRFOQ@ .

Setting the number of slots

This section describes how to configure the number of cartridge
slots from the Slots Setup Menu on the library's front panel. You
can use this menu to set two types of slot configurations:
ΠHardware slots. The hardware slots setting, called Total
ΠSoftware slots. The software slots setting, called Max
68
É
Important
cartridge, you must reset the Number of Cleans
and re-enable Autoclean (see
Installed Slots, allows you to configure the library for the actual
number of slots the library contains.
Addressable Elements, allows you to configure the library for the
number of slots you want the software application to
recognize.
When you install a new cleaning
page 66).
Exabyte X200