Exabyte X200 Library Installation And Operation Manual page 76

Chapter 4
Enabling LCD security
1. From the Configuration Menu, select the System Setup Menu.
2. From the System Setup Menu, press >6HFXULW\@ . The following
3. Select a three-digit password. Press >1H[W^ ' LJLW@ and >3UHYLRXV^ ' LJLW@ to
4. When you are finished, press >(QDEOH^ 6 HFXULW\@ . A confirmation
Disabling LCD security
1. From the Configuration Menu, select System Setup Menu.
2. Press >6HFXULW\@ .
62
screen message appears:
move from column to column and >@ and >@ to change the
numbers. (The default password is 000.)
É
Important
select to enable security; you must use the same
passw ord to turn security off.
message appears. Press the >6DYH@ softkey. Or, to exit without
enabling security, press >&DQFHO@ .
Note: If you used the application software to enable security,
you must use the software to disable security. Refer to
your software documentation or the Exabyte X80 and
X200 Libraries SCSI Reference.
Make note of the password you
Exabyte X200