Exabyte X200 Library Installation And Operation Manual page 241

4
4
4
4
4
4
4
After checking the items above, reset the library as described on
page
Installation and Operation
Narrow SCSI and wide SCSI. Make sure all devices within
the library are wide SCSI, or use appropriate SCSI adapters to
connect the wide library to narrow devices on the SCSI bus
(see page 237).
SCSI cable lengths. Make sure the internal SCSI cabling does
not exceed maximum lengths (see
Termination. Make sure the SCSI buses are properly
terminated as described in
previously terminated the SCSI bus but is no longer at the
physical end of the bus, remove the terminators from that
device.
Compatibility. Make sure that your tape drives and library are
compatible with the SCSI adapter card and application
software you plan to use.
SCSI adapter card installation. Make sure that you installed
your SCSI adapter card correctly. Refer to the documentation
that came with your card for installation and troubleshooting
instructions. Pay special attention to steps describing setting
various jumpers and switches on the card. Make sure that the
card is properly seated.
Software installation. Make sure that your application
software is installed correctly. (Refer to the software
documentation.) Pay special attention to steps that describe
how to configure the software for use with the library.
Control mode. Make certain the library is operating in the
correct control mode. For most applications, the control mode
should be set to SCSI. See
92.
page 241).
Appendix B. If one SCSI device
page 84 for more information.
Troubleshooting
227