Exabyte X200 Library Installation And Operation Manual page 266

Appendix C
Error
number
Did not read BC data. The bar
code scanner could not read the
bar code label in the fixed
cartridge slot because of a
firmware or hardware problem.
67
Robot FRU data bad. The library
was unable to retrieve robot
calibration data from the robot
70
field replaceable unit (FRU).
Parameter > limit. Firmware
error.
71
Front door open. The front door
was opened before the library
completed its commands.
72
252
Description Corrective action
This error appears on the Label
Information screen.
Œ
Make sure the library and tape drives
are not being used by any host, then
reset the library from the operator
panel.
Œ
If the error persists, contact your
service provider. You may be asked to
supply a diagnostic listing; you may
need new firmware.
Œ
Make sure the library and tape drives
are not being used by any host, then
reset the library from the operator
panel.
Œ
If the error persists, contact your
service provider.
Œ
Make sure the library and tape drives
are not being used by any host, then
reset the library from the operator
panel.
Œ
If the error persists, contact your
service provider. You may be asked to
supply a diagnostic listing; you may
need new firmware.
Œ
Close and lock the front door.
Œ
Make sure the library and tape drives
are not being used by any host, then
reset the library from the operator
panel.
Exabyte X200