Exabyte X200 Library Installation And Operation Manual page 268

Appendix C
Error
number
Drive not talking. The library was
unable to communicate with the
drive.
78
R axis not retracted. The robot
did not move to home before the
current servo command was
attempted.
79
EE port failed to extend. The
80
entry/exit port could not extend.
EE port failed to return. The
entry/exit port could not retract.
81
254
Description Corrective action
Œ
If you just replaced a tape drive, make
sure the drive carrier is seated
properly (see page
Œ
Make sure the library and tape drives
are not being used by any host, then
reset the library from the operator
panel.
Œ
If the error persists, contact your
service provider.
Œ
Open the door and look for anything
that might be obstructing the robot
along its reach axis.
Œ
Make sure the library and tape drives
are not being used by any host, then
reset the library from the operator
panel.
Œ
If the error persists, contact your
service provider.
Œ
Open the door and look for anything
that might be obstructing the
movement of the entry/exit port.
Œ
Make sure the library and tape drives
are not being used by any host, then
reset the library from the operator
panel.
Œ
If the error persists, contact your
service provider.
122).
Exabyte X200