Exabyte X200 Library Installation And Operation Manual page 130

Chapter 8
Step 1 – Remove the old power supply
To remove the old power supply:
1. If you are replacing a power supply and do not have a second
2. From the back of the library, use a # 2 Phillips screwdriver to
3. To completely disengage the power supply from the library,
116
power supply installed, turn the library's power off.
If you have two power supplies and the second power supply
is operational, you can hot-swap the failed power supply by
leaving the power on.
release the two captive screws on the power supply you want
to remove.
pull the release lever out until it forms a right angle with the
back of the library, as shown below.
Captive
screw
Release
lever
Captive
screw
Exabyte X200