Replacing A Power Supply - Exabyte X200 Library Installation And Operation Manual

11. Insert the metal tabs into the slots and push the panel into
12. Replace the three screws on the air filter cover.
Replacing a pow er supply
This section describes how to replace a failed power supply. To
order a replacement power supply kit, see
on the inside of the back cover.
Required tools and equipment
Make sure you have the following:
ΠNew power supply
Π# 2 Phillips screwdriver
Protect from ESD
Ensure that the environment is free of conditions that could cause
electrostatic discharge (ESD). If possible, use a grounded static
protection wristband during installation. If a wristband is not
available, touch a known grounded surface, such as the library's
metal chassis.
Installation and Operation
place so that it fits snugly against the front of the library.
Note: Make sure the screw holes in the air filter cover line up
with the screw holes in the chassis stand-offs.
Routine Service
"Contacting Exabyte"
115