Library Operation Problems - Exabyte X200 Library Installation And Operation Manual

Chapter 13

Library operation problems

If the library has been successfully operating in the past, but is
now experiencing problems, check the following:
4
4
4
4
4
4
228
Control mode. If you are using an application software
package to control robot operations, the library must be set to
SCSI mode. See page 85
Security. Make sure that security is set correctly for the
operation you are trying to perform. If security is enabled, you
cannot perform many operations on the LCD and you cannot
open the door. Security can be enabled from the LCD (see
page 62) or from your application software with a SCSI
command.
Door open. Make sure the door is closed and locked. You can
check the Front Door Open and Key Lock lines on the System
Sensors screen to determine if the door and key lock sensors
are properly working (see
Robot operation. You can use the selections in the
Maintenance Menu (Library Command and Library
Diagnostics) to determine if the robot is functioning properly.
See page 165.
Fuse. Make sure the fuse is good (check for a broken filament
inside the glass cylinder). To replace a fuse, see
Firmware level. Make sure your library contains correct
versions of library flash and boot code. To view the current
library code versions, see
these code versions are the most current, check the Exabyte
web site at www.exabyte.com.
for more information.
page 189).
page 174. To determine whether
page 109.
Exabyte X200