Exabyte X200 Library Installation And Operation Manual page 224

Chapter 12
2. Activate the FTP utility you are going to use to transfer the
Step 3 – Copy the current flash code
As a precautionary measure, you can make a copy of the current
library or Ethernet flash code. You can do this by using an FTP
command.
To copy the current flash code, follow these steps:
1. Create a directory named after the current (not the new) flash
2. Copy the current flash code from the library or Ethernet card
Step 4 – Rename the new flash code
Before you can transfer the new flash code to the library or
Ethernet card, you need to rename the new file so that the library
can recognize it when the file is transferred via FTP.
210
flash code to the library or Ethernet card.
Note: If you do not know the FTP user name or password,
you can view them from the Ethernet Security screen
on the library's front panel (see
code version number. For example, if the current library flash
code version is 2.1.7, name the directory 2_1_7.
Note: If necessary, you can obtain the current library or
Ethernet flash code version number from the
Information screen on the library's LCD. See
into the directory you just created, as follows:
ΠFor the library, get the file named
ΠFor the Ethernet card, get the file named
page 72).
page
arrowhed.sqs
enet.sqs
Exabyte X200
174.