Exabyte X200 Library Installation And Operation Manual page 264

Appendix C
Error
number
D LM629 reset fail. The library
could not reset the servo chip for
the drum axis.
56
No label. The bar code scanner
could not read the bar code label
because there was no label on
the cartridge.
60
Label read error. The bar code
scanner could not read the bar
code label because the label was
unreadable.
61
Not present. The bar code
scanner could not read the bar
62
code label because there was no
cartridge present.
250
Description Corrective action
Œ
Make sure the library and tape drives
are not being used by any host, then
reset the library using the operator
panel.
Œ
If the error persists, contact your
service provider.
This error appears on the Label
Information screen.
Œ
If the cartridge does not have a label,
place a label on the cartridge (see
page 30).
Œ
If the error persists, contact your
service provider.
This error appears on the Label
Information screen.
Œ
If the cartridge has a label, reposition
or replace it (see
Œ
If the label does not contain a
checksum character, make sure the
Verify Checksums option is OFF (see
page 81).
Œ
If the error persists, contact your
service provider.
This error appears on the Label
Information screen.
If necessary, install a cartridge.
page 30).
Exabyte X200