Exabyte X200 Library Installation And Operation Manual page 165

Step 4 – Connect the tape drive to the SCSI bus
1. Decide which SCSI bus you want to use for the tape drive.
Note: When you install a new tape drive, a default SCSI ID is
2. Using wide SCSI cables and the connectors on the back of the
Step 5 – Power on the library
1. Reconnect the power cord.
2. Turn on the library. The library will take several minutes to
Installation and Operation
assigned in sequence with the library and other drives. To
change the SCSI ID after you power on the library, see
page 56.
tape drive, connect the drive to the SCSI bus.
To avoid damaging the tape drive, make sure the
library is pow ered off w hen you connect it to the
SCSI bus.
É
Important
the SCSI connectors, make sure you tighten the
SCSI cable jack screw s to no more than
2.0 inch-pounds (2.3 kg-cm) of torque.
calibrate the new drive and complete its power-on self-test.
CAUTION
When you attach the SCSI cables to
Library Upgrades
151