Exabyte X200 Library Installation And Operation Manual page 112

Chapter 7
5. To clean Tape Drive 1, press >6WDUW@ . To clean another tape drive,
6. Confirm that the cleaning was done by looking at the LEDs
7. When the cleaning is complete, return the library to SCSI
98
press the following softkeys:
>6HW^ ' HVW@
>@ (until you reach the tape drive you want to clean)
>6DYH@
>6WDUW@
When you select a drive, the following activities occur:
ΠThe robot picks the cleaning cartridge from the fixed slot
and inserts it in the tape drive.
ΠThe tape drive automatically performs the cleaning process
and unloads the cartridge when the process is complete.
This may take several minutes.
ΠThe robot automatically picks the cartridge from the tape
drive and replaces it in the fixed cartridge slot.
on the front of the tape drive. The top LED should be off. If
the LED is still on, the cleaning cartridge may need to be
replaced. Obtain a new cleaning cartridge and clean the tape
drive again.
Note: If the top LED is still on after the second cleaning, there
may be a problem with the tape drive. Contact your
service provider.
mode and re-enable security, if appropriate.
Exabyte X200