Laser Safety Labels - Exabyte X200 Library Installation And Operation Manual

Appendix D
Tape drive interlock
When a tape drive is removed, the software controlling the robot
and laser bar code scanner receives a status signal from a sensor
at the drive interface. This signal tells the software that a drive is
no longer present. The software then prevents the robot from
moving to the area in front of the empty drive slot.

Laser Safety Labels

The library contains laser safety notice labels that are located on
the service access cover and the back of the library. The figure on
the following page shows the locations of these labels.
Note: If your library contains less than 10 tape drives, laser safety
262
FDA CAUTION
Use of controls or adjustments or performance
of procedures other than those specified herein
may result in hazardous laser light exposure.
labels are also placed on the service access covers.
Exabyte X200