Table of Contents
Advertisement
Chapter 12
Step 1 – Connect the serial cable
To connect the serial cable to the library and host computer,
connect the 9-pin cable to the back of the library and to the host
computer. The following figure shows the location of the 9-pin
serial port on the back of the library.
Step 2 – Set the library's baud rate
1. Make sure the library is in a ready state (idle operating status,
2. If necessary, disable security (see
202
no errors, and so on).
Serial port
page
62).
Exabyte X200
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the X200 Library and is the answer not in the manual?
Questions and answers