Ejecting A Cartridge From A Tape Drive - Exabyte X200 Library Installation And Operation Manual

The following table describes the LED combinations that occur
during normal tape drive operation.
POST*
or reset
Top LED
M iddle
LED
Bottom
LED
* POST = power-on self-test
m = off
Legend:

Ejecting a cartridge from a tape drive

You may need to manually eject a cartridge from the tape drive
before replacing a drive, calibrating the library, or if a hardware
error occurs.
To eject a cartridge from the drive:
1. If security has been enabled, disable it (see
2. Unlock and open the library door.
3. Press the unload button on the right side of the tape drive's
4. Wait for the cartridge to eject, then remove the cartridge.
Installation and Operation
Error or Ready
failed (no tape
POST loaded)
j
n/a
l = on j= flash
faceplate.
Tape Drive State
Ready Normal
(tape tape
loaded) motion motion
n/a n/a
j
n/a = not applicable (may be any state)
Tape Drive Operation
High
Time to Clean in
speed
clean progress
n/a
n/a
j
n/a
fast
page 62).
j
95