Exabyte X200 Library Installation And Operation Manual page 163

Step 3 – Install the tape drive
To install a tape drive in the library:
1. Make sure the tape drive model (M2 or Mammoth) matches
2. Also, make sure the symbol on the new drive carrier (LVD or
Installation and Operation
the drives already installed in the library.
Do not mix M2 and Mammoth drives in the
library. Mixing drive models could cause data
loss or drive failure.
HVD) matches the symbols on the already-installed drives.
The SCSI symbols that distinguish between LVD and HVD are
shown in the following figure.
High-voltage differential (HVD)
CAUTION
Low-voltage differential (LVD)
Library Upgrades
149