Exabyte X200 Library Installation And Operation Manual page 75

M ethods for setting library security
You can set library security in one of two ways:
ΠLCD security. LCD security is enabled and disabled from the
ΠSCSI security. SCSI security is enabled and disabled from the
The method you use to enable security (LCD or SCSI) must also
be used to disable security. That is, if you enable security from the
operator panel (LCD), you must disable it from the LCD. If you
enable security from the application software (SCSI), you must
disable it from SCSI.
To determine how security has been set in the library, look at any
LCD screen containing the Robot Control Mode and Security box
at the bottom of the screen, as shown in the following figure.
Security (enabled or disabled) remains in effect across resets and
power cycles.
Installation and Operation
operator panel using the Configuration Menu, as described in
this section.
application software using a MODE SELECT command.
However, SCSI security alone does not prevent the library
door or the entry/ exit port door from being opened or closed;
you must use a PREVENT/ ALLOW MEDIUM REMOVAL
command. For more information about SCSI security, see your
software documentation or the Exabyte X80 and X200 Libraries
SCSI Reference.
Library Configuration
61