Exabyte X200 Library Installation And Operation Manual page 162

Chapter 9
To remove the drive bay's service access cover:
1. From the back panel, use a # 2 Phillips screwdriver to release
Captive
screws
2. Remove the cover so that the drive slot is open. (You can
148
the two captive screws that secure the service access cover to
the drive slot where you want to install the new tape drive, as
shown in the following figure.
discard the cover.)
Do not power on the library with a drive slot open.
You must install a tape drive in the open slot before
powering on the library.
:$51,1*
Exabyte X200