Exabyte X200 Library Installation And Operation Manual page 190

Chapter 11
SCSI M ode Parameters screen
The SCSI Mode Parameters screen displays the settings of various
operating mode parameters. These parameters are equivalent to
the parameters reported by the library in response to a MODE
SENSE command issued by the application software.
Typically, the values of these parameters are changed by a MODE
SELECT command. For information about the MODE SENSE and
MODE SELECT commands, refer to the Exabyte X80 and X200
Libraries SCSI Reference.
The SCSI Mode Parameters screen displays three types of
parameters, as follows:
ΠElement Address Page
ΠParity Page
ΠLCD Page
For each parameter, the SCSI Mode Parameters screen shows the
Current, Saved, and Default values:
ΠThe current value is the value currently active. It is either the
ΠThe saved value is the value specified as the power-on default
ΠThe default value is the original value set at the factory.
176
power-on default or a temporary value set by the latest MODE
SELECT command.
by a MODE SELECT command. After a saved value has been
specified with a MODE SELECT command, this value takes
effect immediately and each time you power on the library.
Exabyte X200