Exabyte X200 Library Installation And Operation Manual page 272

Appendix C
Error
number
130 SCSI chip error; SCSI
unexpected int; SCSI int stuck
131
error. There was a SCSI chip
failure.
132
133
134
135
136
137
Chassis EEPROM failed.
190 Communication with the chassis
EEPROM has failed.
Robot EEPROM failed.
191 Communication with the robot
EEPROM has failed.
Drive comm error. The library
could not communicate with a
tape drive because of a problem
with the drive's SCSI ID.
192
All slots are full. The robot could
194 not find an empty cartridge slot
in Demo Mode.
258
Description Corrective action
Œ
Make sure all devices (including
terminators) are differential.
Œ
Make sure the library and tape drives
are not being used by any host, then
reset the library from the operator
panel.
Œ
If the error persists, contact your
service provider. You may be asked to
supply a diagnostic listing; you may
need new firmware or a new controller
card.
Œ
Make sure the library and tape drives
are not being used by any host, then
reset the library from the operator
panel.
Œ
If the error persists, contact your
service provider.
Œ
If you just replaced a tape drive, make
sure the drive carrier is seated
properly.
Œ
Make sure the library and tape drives
are not being used by any host, then
reset the library from the operator
panel.
Œ
If the error persists, contact your
service provider. You may be asked to
supply a diagnostic listing; you may
need new firmware or a new controller
card.
Open the library door and remove at least
one cartridge from a magazine.
Exabyte X200