Exabyte X200 Library Installation And Operation Manual page 195

The following table describes the information in the SCSI Sense
Data screen.
Installation and Operation
SCSI Sense data
Host ID The SCSI ID of the host(s) connected to the library.
Sense This is the sense key returned by the REQUEST SENSE
Key command. The sense keys are:
0h–No Sense There is no specific sense key information
to report.
2h–Not Ready The library is not ready to perform
motion commands.
4h–Hardw are Error The library detected a hardware
failure during a self-test or while performing a
command. Operator intervention may be required.
5h–Illegal Request There was an illegal parameter in the
command descriptor block or in the additional
parameters supplied as data for a command, or the
library is in the wrong mode to execute the command.
6h–Unit Attention The cartridge inventory may have
been violated.
Bh–Aborted Command The library aborted the
command. The initiator may be able to recover by trying
the command again.
ASC This is the Additional Sense Code, which, along with the
Additional Sense Code Qualifier, provides information
describing a specific error condition.
ASCQ This is the Additional Sense Code Qualifier, which,
along with the Additional Sense Code, provides
information describing a specific error condition.
Byte This is the Sense Key Specific data, which provides
15 additional information about an error condition. This
information is valid only for the Illegal Request (5h)
sense key.
Library Status
181