• Install the stopper plate.
$
When installing the plate, fit the protrusion A of plate to
the one of the bearing stopper grooves.
NOTE:
Two kinds of plates are available to lock the stopper at the proper
position.
FINAL GEAR CASE INSTALLATION
Installation is in the reverse order of removal.
NOTE:
Refer to the following pages for the details of each step.
• Install the final gear case.
• Tighten the final gear case bolts to the specified torque.
! Final gear case nut: 40 N . m (4.0 kgf . m, 29.0 lb-f )
• Install the rear wheel. ("7-41)
• Pour final gear oil. ("2-15)
SHAFT DRIVE 4-23