Suzuki VL800 Service Manual page 217

WHEEL DAMPER
• Install the dampers.
NOTE:
If soap water is applied around the damper, it makes the job easier.
DRIVEN JOINT
• Install the driven joint.
NOTE:
Apply grease to the O-ring and the final gear spline before install-
ing the driven joint.
For USA
# 99000-25030: SUZUKI SUPER GREASE "A"
For the other countries
# 99000-25010: SUZUKI SUPER GREASE "A"
• Apply THREAD LOCK SUPER "1303" to the thread of driven
joint stopper bolts.
) 99000-32030: THREAD LOCK SUPER "1303"
• Tighten the driven joint stopper bolts to the specified torque.
$ Driven joint stopper bolt: 10 N . m (1 0 kgf m, 7.0 lb-ft)
• Bend up the washer to lock the bolts.
REAR WHEEL
• Install the spacer 1.
• Apply grease to the final gear s line before installing the rear
wheel.
For USA
# 99000-25030 SUZUKI SUPER GREASE "A"
For the other countries
# 99000-25010: SUZUKI SUPER GREASE "A"
• Remount the rear wheel spacer and rear axle.
NOTE:
Refer to the page 7-37 for the spacer positioning.
• Tighten the rear axle nut to the specified torque.
$ Rear axle nut: 65 N . m (6.5 kgf . m, 47 lb-ft)
NOTE:
After remounting the rear wheel, check for proper brake opera-
tion.
• Install the exhaust pipe and muffler. ('3-5)
• Install the rear fender ('7-3)
CHASSIS 7-41