Suzuki VL800 Service Manual page 95

3-56 ENGINE
• Tighten the secondary gear case bolts to the specified torque.
# Secondary gear case bolt (Initial): 15 N . m
NOTE:
Fit the washer to the bolt A .
• Tighten the secondary driven bevel gear bolt to the specified
torque.
NOTE:
* Hollow portion B of the secondary driven gear assembly faces
inside.
* Apply a small quantity of THREAD LOCK SUPER "1303" to the
bolt.
' 99000-32030: THREAD LOCK SUPER "1303"
# Secondary driven bevel gear bolt: 23 N . m
DRIVESHAFT BOLT/SECONDARY DRIVEN GEAR SHAFT
NUT
• Install the universal joint on the secondary driven gea shaft.
• While holding the universal joint with a adjustable wrench,
tighten the secondary drive gear shaft nut 1 and driveshaft
bolt 2 to the specified torque.
$
Driveshaft bolt 2 has left-hand thread.
" 09900-18710: Hexagon socket (12 mm)
# Secondary drive gear shaft nut 105 N . m
Driveshaft bolt: 65 N . m (6 5 kgf m, 47.0 lb-ft)
WATER PUMP
• Install the new O-ring and new gasket.
• Tighten the water pump mounting screws.
$
Use the new O-ring to prevent oil leakage.
(1.5 kgf . m, 11.0 lb-ft)
(Final) : 22 N . m
(2.2 kgf . m, 16.0 lb-ft)
(2.3 kgf . m, 16.5 lb-ft)
(10.5 kgf . m, 76.0 lb-ft)