Suzuki VL800 Service Manual page 175

• Install the new mechanical seal with a suitable size socket
wrench and the special tool.
NOTE:
The new mechanical seal has been applied the sealer A .
& 09924-84521: Bearing installer
• Install the new bearing with the special tool.
& 09924-84521: Bearing installer
NOTE:
The stamped mark on the bearing faces crankcase side.
• Install the rubber seal 1 into the impeller.
• After wiping off the oily or greasy matter from the mechanical
seal ring, install it into the impeller.
NOTE:
The marked side B of the mechanical seal ring faces the impel-
ler.
• Install the impeller and impeller shaft to the water pump body.
• Install the pin 2.
COOLING SYSTEM 6-13