Suzuki VL800 Service Manual page 246

8-14 ELECTRICAL SYSTEM
Measure the relay coil resistance between the terminals using
the multi circuit tester. If the resistance is not within the specified
value, replace the starter relay with a new one.
" 09900-25008: Multi circuit tester set
# Starter relay resistance: 3 – 7 Ω Ω
SIDE STAND/IGNITION INTERLOCK SYSTEM
PARTS INSPECTION
Check the interlock system for proper operation. If the interlock
system does not operate properly, check each component for
damage or abnormalities. If any abnormality is found, replace the
component with a new one.
SIDE-STAND SWITCH
• Remove the secondary gear case cover.
• Disconnect the side-stand switch coupler and measure the
voltage between Green and Black/White lead wires
" 09900-25008: Multi circuit tester set
$ Tester knob indication: Diode test (%)
NOTE:
If the tester reads under 1 4V when the tester probes are not
connected, replace its battery.
GEAR POSITION SWITCH
• Remove the secondary gear case cover.
• Disconnect the gear position switch coupler and check the con-
tinuity between Blue and Black/White with the transmission in
"NEUTRAL".
!
When disconnecting and connecting the gear position
switch coupler, make sure to turn OFF the ignition switch,
or electronic parts may get damaged.
More than 1.4 V
(Tester's battery voltage)