Suzuki VL800 Service Manual page 436

Hide thumbs Also See for VL800:
Table of Contents

Advertisement

14-84
VL800K5 ('05-MODEL)
Step 2
1) Connect the PAIR control solenoid valve coupler.
2) Turn the ignition switch ON.
3) Insert the needle pointed probes to the PAIR control solenoid
valve coupler.
4) Measure the voltage at the wire side coupler between Black
wire and ground.
! PAIR control solenoid valve voltage: Battery voltage
" 09900-25008: Multi-circuit tester set
09900-25009: Needle pointed probe set
& Tester knob indication: Voltage (')
Is the voltage OK?
• Br/B wire open or shorted to ground, or g con-
nection.
• If wire and connection are OK, intermittent trou-
ble or faulty ECM.
YES
• Recheck each terminal and wire harness for
open circuit and poor connection.
• Replace the ECM with a known good one and
inspect it again.
NO
Open or short circuit in the Br/B wire.
3) After repairing the trouble, clear the DTC using SDS tool.
($14-39)
(+ Black – - Ground)
2
V
Wire harness side

Advertisement

Table of Contents
loading

This manual is also suitable for:

Intruder vl800

Table of Contents