Suzuki VL800 Service Manual page 99

Hide thumbs Also See for VL800:
Table of Contents

Advertisement

3-60 ENGINE
• Install the cam driven gear 1 after installing the springs, pins
and gearshift pawls.
• Install the cam guide and the pawl lifter.
• Apply a small quantity of THREAD LOCK "1342" to the nuts.
) 99000-32050: THREAD LOCK "1342"
• Install the gearshift return spring properly.
• Install the gearshift shaft with the cen er of shift gear on the
shaft aligned the center of gearshift cam driven gear.
OIL PUMP
• Install the oil pump.
# Oil pump mounting bolt: 11 N . m (1.1 kgf . m, 8 lb-ft)
NOTE:
Set the oil pump shaft end A to the water pump shaft B .
• Install the washer 1 and pin 2.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Intruder vl800

Table of Contents