Suzuki VL800 Service Manual page 519

NOTE:
Using the hand-press is recommended to remove the crankshaft
journal bearings. However, the crankshaft journal bearings can
be removed by using with the following special tools.
" 09924-84510: Bearing installer set
09924-74570: Final drive gear bearing remover/installer
• Set the specified crankshaft journal bearings to the special
tool.
#
* Before setting the bearing, apply enough engine oil
to the special tool and bearings.
* When setting the bearing, align the bearing side with
the engraved line A and also the bearing edge with
the mating surface of the special tool.
" 09913-60241: Journal bearing remover/installer
• Tighten the special tool bolt to the specified torque.
$ Special tool bolt: 23 N·m (2 3 kgf-m, 16.5 lb-ft)
#
Before installing the bearings, lightly shave off the
sharp edge part of the crankcase chamfer by using an
oilstone and wash the crankcase bore with enough
engine oil.
VL800/TK6 ('06-MODEL) 16-15
Bearing
Sharp edge