Suzuki VL800 Service Manual page 159

THROTTLE POSITION SENSOR POSITIONING
• Install the throttle position sensor with the flats on the throttle
shaft end securely engaged with the slot on the throttle posi-
tion sensor.
• Measure the resistance
sensor terminals as shown in the illustration.
& Throttle position sensor resistance
• Measure the resistance
sensor terminals as shown in the illustration.
• Fully open the throttle valve with the throttle lever.
• Position the throttle position sensor until resistance
– 4.63 kΩ.
• When the resistance
throttle position sensor mounting screws.
& Throttle position sensor resistance
• After the assembly and installation on the engine have been
completed, perform the following adjustment.
* Throttle cable adjustment (" 2-11)
* Idle speed adjustment (" 2-10)
CARBURETOR HEATER
• Apply thermo-grease to the threads and tighten the carburetor
heater. (for E-02, 19)
) 99000-59029: THERMO GREASE
* Carburetor heater: 3 N . m (0.3 kgf . m)
Ω 1
between the throttle position
Ω 1
Ω 2
between the throttle position
Ω 2
is within specification, tighten the
Ω 2
3.09 – 4.63 kΩ Ω
: Approx. 5 kΩ
Ω 2
is 3.09
:
FUEL AND LUBRICATION SYSTEM 5-25
Ω
2
Ω
1