18-32 VL800/C/TK9 ('09-MODEL)
"C41" (P0230) FP RELAY CIRCUIT MALFUNCTION
On model K9, the connector terminals to be used for checking
sensors for voltage, resistance or continuity at the ECM terminal
are located as shown in the illustration.
* Refer to page 14-82 for details.
"C42" (P1650) IG SWITCH CIRCUIT MALFUNCTION
DETECTED CONDITION
Ignition switch signal is not input in the ECM.
INSPECTION
* Refer to the IGNITION SWITCH INSPECTION for details ( Page 8-30)
ECM coupler (Harness side)
POSSIBLE CAUSE
• Ignition system circuit open or short.
• ECM malfunction.