Suzuki VL800 Service Manual page 9

"
* If parts replacement is necessary, replace the parts with Suzuki Genuine Parts or their equiva-
lent.
* When removing parts that are to be reused, keep them arranged in an orderly manner so that
they may be reinstalled in the proper order.
* Be sure to use special tools when instructed.
* Make sure that all parts used in reassembly are clean. Lubricate them when specified.
* Use the specified lubricants, bonds, or sealants.
* When removing the battery, disconnect the - battery lead wire first and then the + battery lead
wire.
* When reconnecting the battery, connect the + battery lead wire first, then the - battery lead
wire. Finally, cover the + battery terminal with the terminal cover.
* When performing service to electrical parts, disconnect the - battery lead wire, unless the
service procedure requires the battery power.
* When tightening cylinder head and crankcase nuts and bolts tighten the larger sizes first.
Always tighten the nuts and bolts from the inside working out diagonally and to the specified
torque.
* Whenever you remove oil seals, gaskets, packing, O rings, self-locking nuts, locking washers,
cotter pins, circlips, and other specified parts, be sure to replace them with new ones. Also,
before installing these new parts, be sure to remove any left over material from the mating
surfaces.
* Never reuse a circlip. When installing a new circlip, take care not to expand the end gap larger
than required to slip the circlip over the shaft. After installing a circlip, always ensure it is
completely seated in its groove and securely fitted.
* Use a torque wrench to tighten fasteners to the specified torque. Wipe off grease and oil if a
thread is smeared with them.
* After reassembling, check parts for tightness and proper operation.
* To protect the environment, do not unlawfully dispose of used motor oil, engine coolant, all
other fluids, batteries, and ti es.
* To protect the earth's natural resources, properly dispose of used motorcycles and parts.
GENERAL INFORMATION 1-3