Combination Meter Inspection; Led (Light Emitting Diode); Fuel Level Meter Inspection - Suzuki VL800 Service Manual

Hide thumbs Also See for VL800:

Table of Contents

18-60 VL800/C/TK9 ('09-MODEL)

COMBINATION METER INSPECTION

Check that the LED lights (FI indicator light, Oil pressure indicator light and Engine coolant indicator light)

immediately after turning the ignition switch ON. Also, other LED lights (Neutral indicator light, High-beam

indicator light and Turn signal indicator light) can be checked by depending on each switch position.

If the LED fails in operation, replace the combination meter until with a new one after checking its wire har-

ness/coupler.

• Keep the motorcycle upright with a jack or wooden block.

• Release the side-stand or push the side-stand switch.

• Remove the fuel tank. ( Page 14-93)

• Connect the speedometer.

• Connect each resistor between the Y/B and B/W lead wire at

the wire harness.

• Turn the ignition switch "ON" position and wait for approx. 26

• Check the display of fuel meter as shown below. If any abnor-

mality is found, replace the speedometer with a new one.

To fuel pump

More than 203 Ω

Table of Contents

Intruder vl800