STARTER CLUTCH SERVICING
• Hold the rotor with off-set wrench and remove the starter clutch
securing bolts.
• When fitting the one way clutch to the guide 1, position flange
side A of one way clutch to the rotor side.
• Apply THREAD LOCK SUPER "1303" to the securing bolts and
tighten them to the specified torque while holding the rotor with
off-set wrench.
' 99000-32030: THREAD LOCK SUPER "1303"
# Starter clutch securing bolt: 26 N . m (2.6 kgf . m, 19.0 lb-ft)
OIL PUMP
• Rotate the oil pump by hand and check that it moves smoothly.
• If it does not move smoothly, replace the oil pump assembly.
Do not attempt to disassemble the oil pump assembly.
The oil pump is available only as an assembly.
ENGINE 3-45