Power Saver Mode; Entering The Power Saver Mode; Exiting The Power Saver Mode - Fuji Xerox ApeosPort-VI C7771 User Manualline

Product Overview

Power Saver Mode

The machine is equipped with the Power Saver mode that saves electricity by reducing
power consumption.
The Power Saver feature has two modes: Low Power mode and Sleep mode.
Low Power Mode
In this mode, the power to the control panel is lowered to save power.
Note
Sleep Mode
In this mode, the power supply to devices such as hard disk drive is suspended and the
power is lowered more than in the Low Power mode.
2

Entering the Power Saver Mode

When the machine enters the Power Saver mode, the touch screen is lit off and the <Power
Saver> button on the control panel is lit on.
The machine enters the Power Saver mode by the following instances:
Pressing the <Power Saver> button
The machine is not operated, data is not received, or a job is not processed until the
machine enters the Power Saver mode.
Smart WelcomEyes does not detect human presence until the machine enters the Power
Saver mode.
Reference
Note

Exiting the Power Saver Mode

The machine exits the Power Saver mode by the following instances:
Pressing the <Power Saver> button on the control panel
Receiving jobs such as print and fax
56
When the machine enters the Low Power mode, the power supply to the fusing unit is suspended.
For how to change the interval for entering the Power Saver mode, refer to "Before Using the Machine" > "Power Saver Mode" >
"Changing the Interval for Entering Power Saver Mode" in the Administrator Guide.
When the machine displays an error such as paper jams, it does not enter the Power Saver mode.
When the machine enters the Power Saver mode while a user is authenticated, the machine exits the
authentication mode.
During operation of the Warmer mode, the machine does not enter the Sleep mode.
When the <Power Saver> button is pressed, the machine enters the Power Saver mode after 5 seconds.
When you press the <Power Saver> button soon after the touch screen is lit off and when the machine does
not enter the Power Saver mode completely, it may take time to exit the mode. Wait a few seconds until the
machine is ready to exit the Power Saver mode and push the <Power Saver> button again.
The machine will not enter the Power Saver mode when [Skip Blank Pages] is enabled. For information on
[Skip Blank Pages], refer to "Tools" > "Fax Service Settings" > "Fax Control" > "Skip Blank Pages" in the
Administrator Guide.
Sufficient distance from the machine is required to keep the power saving state after pressing the <Power
Saver> button. When the specified period of time elapses after pressing the button, the human motion
sensor of the machine starts to detect human presence and then releases the Power Saver mode.