Activating A Channel; Restoring Default Channel Settings - Christie CP2208 User Manual

Field
L/R Display Reference
Frame Rate N:M
L/R Display Sequence
3D Sync Polarity
Dark Time
Output Delay
Phase Delay
8. Tap Activate to activate the channel.

Activating a channel

1. Tap Menu > Channel Setup.
2. Select a channel in the Channel Name list.
3. Tap Activate.

Restoring default channel settings

1. Tap Menu > Channel Setup.
2. Select a channel in the Channel Name list.
3. Tap Defaults.
CP2208 User Manual
020-101916-02 Rev. 1 (08-2015)
Description
Specifies which frame of eye data to display during a specific display
frame. This signal is referenced to the display frame rate which is
specified by the Frame Rate N:M.
Sets how many frames to display per number of frames that form one
complete image. Increase the display frame rate to reduce flicker from
your source(s).
Defines the frame order (L-R or R-L) required for 3D perspective. This
option only has meaning when the Frame Rate factor M is equal to 2. For
this case, two input frames of data are required to constitute a complete
frame of image data. This parameter tells the system which frames go
together to make a complete image. When using Line Interleave as the
3D Sync Input Mode, ensure that Left (L1R1 L2R2) is selected.
Keeps 3D stereo sync output the same as input (true) or reversed
(inverted).
True: 3D L/R sync output from GPO will match L/R sync input.
Inverted: 3D L/R sync output from GPO will be the opposite of sync
input (left = right, right = left).
Creates a blank time interval between left and right frames to allow for
LCD shutter glasses, Z screen, or rotating 3D wheel to synchronize the
output. See Dark Time and Output Delay Notes below. Values between 0
and 65535 are accepted. Tap the Launch Dialog
dark time value.
The non-image time in Microseconds (μ). Offset 3D stereo sync output in
relation to dark time interval. Acceptable values are between -32768 and
32767 are accepted where a positive offset = delay and negative offset =
start early. Tap Launch Dialog to enter the output delay value.
The degree of reference between the left and right sync output. Values
between -180 and 180 are accepted. Tap Launch Dialog to enter the phase
delay value.
Working with Channels
( )
icon to enter the
56