Installing And Setting Up; Safety Precautions - Christie CP2208 User Manual

Installing and Setting Up

This manual is intended for professionally trained operators of Christie high-brightness projection
systems. These operators are qualified to replace the lamp and air filter, but should not attempt to
install or service the projector.
Only accredited Christie technicians who are knowledgeable about the hazards associated with
high-voltage, ultraviolet exposure, and the high temperatures generated by the projector lamp are
authorized to assemble, install, and service the projector. In addition, only Christie accredited
personnel are authorized to perform security procedures such as marriage.
This section provides information and procedures for positioning and installing the projector.

Safety precautions

When installing the projector, observe these important safety rules to avoid personal injury or
damage to the projector:
Warning! Failure to comply with the following could result in serious injury.
• Never look directly into the projector lens or at the lamp. The extremely high brightness can cause
permanent eye damage. For protection from ultraviolet radiation, keep all projector housings intact
during operation. Protective safety clothing and safety goggles are recommended when servicing.
• FIRE HAZARD! Keep hands, clothes, and all combustible material away from the concentrated light
beam of the lamp.
Danger! Failure to comply with the following results in serious injury.
Position all cables where they cannot contact hot surfaces or be pulled or tripped over.
This projector must be operated in an environment that meets the operating range specification, as
listed in Projector Specifications on page
CP2208 User Manual
020-101916-02 Rev. 1 (08-2015)
99.
11