Displaying 3D Diagnostic Test Patterns - Christie CP2208 User Manual

4. Tap Config 2 in the left pane and edit these settings:
a. Select 3D Onsite in the Measured Color list. If this option is not available, see
a measured color gamut data file
b. Select DC28_DCIXYZE_314_351 in the Target Color list.
c. Select YCxCz Inverse ICT in the Color Space list.
d. Select Gamma 2.6 in the Gamma list.
e. Select Linear_9x9x9 in the LUT-CLUT list.
5. Tap 3D Control in the left pane and edit these settings:
a. Select Line Interleave in the 3D Sync Input Mode list.
b. Select 6:2 in the Frame Rate N:M list.
c. Select Left (L1R1 L2R2) in the L/R Display Sequence list.
d. Select True in the 3D Sync Polarity list.
e. Enter 430 in the Dark Time field or enter a value appropriate for your 3D hardware.
f. Enter -120 in the Output Delay field or enter a value appropriate for your 3D hardware.
g. Enter 0 in the Phase Delay field or enter a value appropriate for your 3D hardware.

Displaying 3D diagnostic test patterns

You can use 3D test patterns to verify your 3D hardware is functioning correctly.
1. Tap Menu > Channel Setup.
2. Select a 3D channel in the Channel Name list.
3. Tap 3D Test Patterns.
4. Tap a test pattern.
5. Put on a pair of 3D glasses.
6. Look at the on-screen image, and then close your left eye and look at the image through your
right eye. Switch when the image alternates.
3D Test Pattern
RGB-12bit -3D Dynamic Range
RGB-12bit-3D Four Quadrant
RGB-12bit-3D Full White
RGB-12bit-3D Half Descending
RGB-12bit-3D Horizontal Ramp
RGB-12bit-3D L-Pattern
CP2208 User Manual
020-101916-02 Rev. 1 (08-2015)
on page 79.
Action
Alternates between two images.
Alternates between two images.
Alternates between two 100% white images.
Alternates between four images.
Alternates between two horizontal ramp images.
Alternates between two images.
Viewing 3D Content
Defining
81