Christie CP2208 User Manual page 90

back of the reflector and guide the lamp onto the cathode clamp. Be careful not to hit the
lamp against the reflector.
e. Thread on and hand-tighten the cathode nut. Ensure the smooth portion of the nut is
against the cathode clamp.
f. Tighten the cathode clamp with a hex key.
6. Align the ring terminal on the anode wire with the mounting position ensuring the crimped side
of the wire is facing out. Tighten the anode screw. Route anode lead away from nearby metal
surfaces.
7. Close the lamp access door and tighten the two thumbscrews.
8. Close the firewall door and tighten the two thumbscrews.
9. Close and lock the rear access door. Ensure the hex key is placed back into its holder before
closing the rear access door.
10. Connect the projector to AC power and then turn the projector on.
11. Tap Menu > Advanced Setup > Lamp Change Wizard.
12. Tap Next.
13. Complete these fields:
Field
Type
Serial Number
Reason for Change
Lamp Expiry (Hours)
Hours Used
14. Tap Save.
15. Tap Next.
16. Align the lamp. See
CP2208 User Manual
020-101916-02 Rev. 1 (08-2015)
Description
The lamp type.
The lamp serial number.
The reason the lamp was changed.
The number of hours the lamp can operate before replacement.
This field is auto-populated.
The number of hours the lamp has operated before installation.
Aligning the lamp on page 29.
Maintenance
90