Installing the touch panel controller
1. Attach the mounting bracket to the touch panel controller using the three M4 screws and the 3
mm hex driver provided.
2. Slide the mounting bracket into the bracket support.
3. Connect the connector from the TPC to the port on the rear of the projector.
Installing the lens
The lens seals the projection head, preventing contaminants from entering the main electronics
area. Do not operate the projector without a lens installed. Install a lens plug when you install or
transport the projector.
CP2208 User Manual
020-101916-02 Rev. 1 (08-2015)
Installing and Setting Up
18