Adjusting The Image To Fit The Screen - Christie CP2208 User Manual

b. Insert a 5 mm hex driver through the louvers at an angle below the Y axis adjustment
label until it is firmly seated on the Y axis adjustment screw.
c. Turn the screw clockwise or counterclockwise until the value in the Intensity field peaks
and then reduces.
d. Remove the hex driver and repeat steps a to c to adjust the Z and X axis.
7. Complete a fine lamp adjustment:
a. Locate the Y axis adjustment label on the operator side of the projector.
b. Insert a 5 mm hex driver through the louvers until it is firmly seated on the Y axis
adjustment screw.
c. Turn the screw slowly clockwise or counterclockwise until you determine the highest
value.
d. Remove the hex driver and repeat steps a to c to adjust the Z and X axis.
8. Verify the value in the Intensity field is greater or equal to the number you recorded in step 4.
If value is lower, repeat steps 6 and Step 7.

Adjusting the image to fit the screen

This procedure must be completed before you complete a boresight adjustment.
1. Verify the projector is properly positioned relative to the screen. See
on page 14.
2. Display a RGB-12bit-Full Screen White test pattern and center the image:
a. Tap the Test Pattern (
b. Tap All Test Patterns.
c. Tap RGB-12bit-Full Screen White.
CP2208 User Manual
020-101916-02 Rev. 1 (08-2015)
) icon in the task bar.
Installing and Setting Up
Positioning the projector
30